Automatic Bridge Controller
Maintaining Your Machine

Tie down cables using cable ties to prevent unnecessary wearing or breaking due to movements or accidents. The cable should not be under tension at any time, they are not made to support mechanical loads. Wrap exposed wire with electrical tape as soon as you see one. Replace damaged cables with new ones. Check all connectors periodically for loose connections. Whem storing the module builder for a prolonged period of time (i.e. the end of a season), do the following preparation: Loosen the bolts holding the top stopper of the tamping cylinder (see Photo 1). Turn the stopper upside down (see Photo 2) and secure it with the bolts. This will prevent the stopper from contacting the sliding rod of the sensor thus removing loading to the internal springs. Cover the conroller box with a piece of cloth or a wooded board to protect it from sunlight. Power up and check the system about two weeks before the start of a harvesting season. Back to Automatic Bridge Controller Manual