GENERAL MAINTENANCE
Lubricate 4 bolt flange bearings before operating unit at beginning of each session. Lubricate periodically throughout the season.
Change Hydraulic fluid filter at beginning of each season and midway through the season.
Hydraulic fluid level should always be visible in sight glass. If not, add any good grade hydraulic fluid that is non-foaming and non-heating.
Lubricate wheel lift assemblies every 7-10 days during seasons.
Check wheel assembly periodically and remove excess debris.
Periodically check to assure all bolted connections are tight.
Wheel bearings were greased at the plant but it is recommended that they be checked each season and packed if necessary.

STORAGE
Module should be stored on level surface with wheel units raised to allow machine to set securely on level surface.
Make sure all hydraulics cylinders and wheel cylinders are fully retracted.
Tamper cylinder should be in the low (transporting) position.
Store Module Builder in barn or shed if possible.